| Imaging
device |
1/2-inch
interline EM-CCD |
| Total
pixels |
680(H)
x 500(V) |
| Effective
pixels |
658(H)
x 489(V) |
| Imaging
area |
6.58(H)
x 4.89(V) mm |
| Pixel
pitch |
10.0(H)
x 10.0(V) µm (Square pixel) |
| Scanning
system |
2
: 1 Interlace |
| Scanning
frequency |
Horizontal
15.734 kHz Vertical 59.94 Hz |
| Synchronization |
Internal |
| Video
output |
|
| VBS
output |
Video
0.7 Vp-p Plus terminal nature |
| Sync |
0.3
Vp-p Negative polarity |
| Burst |
0.3
Vp-p, More than 8 cycles |
| Impedance |
75
Ohms Un-balancing |
| Signal-processing
system |
Digital
processing (Input 10 bit) |
| Signal
to noise ratio (S/N) |
50
dB or more (luminosity signal, Gamma OFF,
minimum gain, without detail boost) |
| Resolution |
Horizontal:
480 lines Vertical: 350 lines (In the central
part) |
Minimum
photographic
subject illumination
|
0.0009
lx (Color in full motion, maximum sensitivity
setup, F1.2, 50 IRE)
0.00005 lx (Monochrome in full motion, maximum
sensitivity
KP-DE500 setup, F1.2, 50 IRE)
0.000015 lx (Color 64 time accumulation, maximum
sensitivity setup. F1.2, 50 IRE)
0.0000008 lx (Monochrome 64 time accumulation,
maximum
sensitivity setup, F1.2, 50 IRE)
|
| Sensitivity
(Gain) setup |
Auto
or a manual (factory set-AUTO) |
| Electronic
shutter |
Shutter:
7 steps /AES (factory set-OFF)
OFF(1/60), 1/100, 1/125, 1/250, 1/500, 1/1000,
1/2000 sec |
| Accumulation
magnification setup |
Auto
or a fixed change is possible. (factory set-OFF)
2, 4, 6, 8, 10, 16, 32, 64 times |
| Backlight
compensation |
An
ON/OFF change is possible (factory set-OFF)
Light-measurement area: Nine area to selection
is possible. |
| The
output for auto iris lenses |
(Square
shape 4 pin, JEITA conformity) A galvanometer
system/video signal |
| White
balance control |
From
the following three modes to selection (factory
set-ATW)
*Only KP-DE500 (color)
ATW: The mode which follows automatically
AWC: The mode which holds a white balance after
an
automatic setup
MANUAL: They are red and the mode which carries
out blue
gain adjustment and unites a white with manual
operation |
| Camera
title character display |
A
display is possible to 22 characters in an alphanumeric
character and a sign
A setup to either of two upper and lower sides
of a screen is
possible in the position of a character. |
B/W
Mode
*Only KP-DE500 (color) |
OFF: The mode of fixation on a color image
On: In high sensitivity monochrome image mode
AUTO: With luminous intensity OFF of high sensitivity
monochrome
image, the mode where ON changes automatically
In addition, it changes, as for luminous intensity
from 3
stages of the HI, the MID and the LOW selective
possibility |
| Picture
quality adjustment menu |
Following
to the menu indication of the picture, various
picture quality adjustments and mode selection
are possible |
| DNR |
Change
of AUTO / MANU (8 steps) (factory set-AUTO) |
| Power
supply voltage |
DC
12V ±1 V |
| Current
consumption |
Approximately
1. 5 A (excluding lens load) |
| Lens
mount |
The
C / CS mount (flange back adjustment mechanism
it is attached) |
| Ambient,
operating |
-
10 ºC - + 50 ºC / 30 - 80% RH
*when in order for you to use with the efficiency
which
long time is stabilized, it continues uses by
all means
+40 ºC please use at below. |
| Ambient,
storage |
Retention:
20 ºC - + 60 ºC / 20 - 90% RH |
| Vibration
endurance |
24.5
m/s2 (10 - 200Hz XYZ direction each 30 minute)
*Please do not add the strong vibration over long
time. |
| External
dimensions |
78(W)
x 63(H) x 170(D) mm
(The lens and the projection section are excluded) |
| Mass |
Approximately
610g (The lens is excluded) |
